Daily 101Home

Daily 101 Home · Episode 1

DRILL 101

Hang a TV or a shelf so it never falls

  • 6 steps
  • Brick or concrete
  • Hammer drill

Scroll to fix it, step by step

DRILL 101

  1. 1mark & scan
  2. 2the right bit
  3. 3depth
  4. 4drill
  5. 5???clean the hole
  6. 6screw

From the first pencil mark to the last turn of the screw. Step five is the one almost everyone skips, and it stays hidden until you get there.

Step 1

Mark and scan

Pencil the holes through the bracket, with a spirit level so the marks sit level.

Run a pipe and cable detector over each mark, and never drill straight above or below a socket or a switch: that’s where its cables run.

Detector beeps? Move the bracket.

Step 2

The right bit

Brick or concrete needs a masonry bit: the one with the wide, flat tip.

Match it to the wall plug. A 6 mm plug takes a 6 mm bit (the size is on the pack).

Too small and the plug won’t go in. Too big and it spins.

Step 3

Set the depth

Push the bit all the way into the chuck and tighten it firmly.

Hold a plug against the bit and wrap a flag of tape where the plug ends. Drill until the tape touches the wall.

A few millimetres deeper than the plug lets it sit flush.

Common mistake

The bit skates across the wall

Start with the hammer action on, and the tip bounces off the hard surface and wanders away from your mark.

You get a scratched wall and a hole in the wrong place. The fix is in how you start.

Step 4

Drill

Start slowly with the hammer off, just to make a dent on your mark.

Keep the drill straight, at 90° to the wall. Once the tip bites, switch the hammer on and let the drill do the work.

Safety glasses on: brick dust flies.

The step almost everyone skips

Why plugs spin forever

Drilling leaves the hole packed with dust. Push a plug in and it sits on that powder instead of gripping the wall.

Then the screw turns and turns, and the plug spins with it.

Step 5

Clean the hole

Blow the dust out with a hand pump, or vacuum it out.

Then tap the plug in until it sits flush with the wall.

It should need only gentle taps. If you have to force it, the hole is too small.

Step 6

Screw

Hold the bracket over the plugs and drive each screw until it’s snug: the screw spreads the plug so it grips the wall.

Don’t overtighten, and check the level one last time.

For a TV, use fixings rated for its weight.

One good hole…

…and that TV isn’t going anywhere.

Every step earns its place: the scan keeps you clear of pipes and cables, the right bit and the tape give a hole of the right size and depth, and a clean hole lets the plug grip.

Everything you need

Materials

  • Drill with a hammer setting1
  • Masonry bit, same size as the plugs1
  • Wall plugs and screws rated for the loadone per hole
  • Pencil and spirit level1 each
  • Pipe and cable detector1
  • Masking tapea few inches
  • Hand blower pump or vacuum1
  • Hammer1
  • Safety glasses1 pair

Safety

  • Scan before every hole, and never drill straight above or below a socket or a switch.
  • Wear safety glasses while drilling (and a dust mask if there’s a lot of dust).
  • This guide is for brick and concrete. Plasterboard (drywall) needs its own fixings.
  • For a TV or anything heavy, use fixings rated for the weight and follow the mount’s instructions.
  • Unplug the drill (or take the battery out) before changing bits.

Watch the Short

DRILL 101 on YouTube

Coming soon

More fixes like this one